Fisher & Paykel SmartDrive Code 144: Phase 1 motor control module software trap

What 144 (SmartDrive) means

On Fisher & Paykel SmartDrive top-load washers in Phase 1, code 144 is a software trap. The motor control module has developed an error severe enough that its program halted, and the display module reports the number. The cycle stops. It reflects the control electronics rather than water, load, or lid, so owner checks are limited to a power reset.

Common causes of 144 (SmartDrive)

Motor control module program halted by an internal error
Control electronics failing or corrupted
A power disturbance interrupting the module

✓ One safe check you can try

1. Press power off and unplug the washer for a full minute. 2. Plug it directly into the wall and start a short cycle with an empty drum. 3. Check that the outlet works and nothing else shares an extension cord. 4. If code 144 returns, stop using the washer and book service. The module is inside the cabinet.

! Why to stop there

A software trap points at the motor control module itself
Repeated power cycling does not fix failing electronics
The module needs bench testing or replacement by a technician

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 235Fisher & Paykel Top-Load Washer Code 235: Lid lock short circuit 253Fisher & Paykel AquaSmart Top-Load Code 253: SmartPump drawing high current 236Fisher & Paykel Top-Load Washer Code 236: Incompatible EEPROM version 254Fisher & Paykel EcoSmart Code 254: motor control software too old

144 (SmartDrive)144 (SmartDrive) questions

What is a software trap?

It is the module's own safety stop. Its program met an error it could not handle, so it halted, and the display reported code 144.

Will a reset clear it?

A one-minute unplug is worth one try. If code 144 returns, the module is the likely cause and no owner adjustment will correct it.

Is this model still repairable?

Phase 1 SmartDrive washers are old, so we confirm parts first. You get a written price before work, and any repair has a 30-day workmanship warranty.