Fisher & Paykel Top-Load Washer Code 232: Communications timeout after 5 seconds

What 232 means

On Fisher & Paykel AquaSmart and EcoSmart top-load washers such as the WA37T26EW and WA42T26GW, and SmartDrive Phase 6 models like the GWL11, code 232 is a 5 second comms timeout. It applies to integrated washers: either the display module or the motor control module did not respond in time. The washer halts and shows the number, much like the other display to motor control communication codes.

Common causes of 232

Display module or motor control module not responding within 5 seconds
Communications wiring loose or damaged
A failing module on the link

✓ One safe check you can try

1. Power the washer off and unplug it for one minute. 2. Plug in and run a short empty cycle. 3. Check that the outlet and cord are in good condition. 4. If code 232 returns, leave the washer unplugged and call us. The link between modules is inside the cabinet.

! Why to stop there

Either board could be the one that stopped replying
The harness needs inspecting with the cabinet open
Swapping modules by guesswork wastes money

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 234Fisher & Paykel Top-Load Washer Code 234: Lid lock open circuit 252Fisher & Paykel EcoSmart Code 252: motor bridge test failed 235Fisher & Paykel Top-Load Washer Code 235: Lid lock short circuit 253Fisher & Paykel AquaSmart Top-Load Code 253: SmartPump drawing high current

232232 questions

What is the 5 second timeout?

The washer waits up to 5 seconds for the other module to answer. If neither reply arrives, the control raises code 232.

Is it the display or the motor control module?

It could be either; the code does not say which stopped answering. A technician tests the link and both modules.

What does the repair look like?

We find the cause, quote the price in writing, and give a 30-day workmanship warranty.