Fisher & Paykel Top-Load Washer Code 112: Motor current sense too high

What 112 means

On Fisher & Paykel AquaSmart and EcoSmart top-load washers such as the WA37T26EW and WA42T26GW, code 112 appears when the motor control module reads motor current at an unrealistically high level for longer than 2 seconds. That points to the motor current sense circuit itself misreading, rather than a real overload. The washer stops mid-cycle and shows the number on its display.

Common causes of 112

Motor current sense circuit reading unrealistically high
Motor control module failing to measure current correctly
A high reading lasting longer than 2 seconds

✓ One safe check you can try

1. Remove any heavy load, press power off, and unplug the washer for a minute. 2. Plug it back in and run a short empty spin. 3. Check that nothing is jammed between the drum and tub that you can see from the top. 4. If code 112 returns, stop using the washer and call us. The current sense circuit is on the control module.

! Why to stop there

The sense circuit sits on the motor control module and cannot be tested by an owner
Continuing to run risks stressing the motor drive
Board repair needs the cabinet open and power disconnected

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 247Fisher & Paykel AquaSmart Code 247: Smart Pump flapper error 248Fisher & Paykel AquaSmart Code 248: Smart Pump top-up error 232Fisher & Paykel Top-Load Washer Code 232: Communications timeout after 5 seconds 249Fisher & Paykel AquaSmart Code 249: pump timed out, no level change

112112 questions

Does code 112 mean the motor is overloaded?

Not necessarily. The control reads current as unrealistically high for more than 2 seconds, which suggests the sensing circuit is misreading rather than the motor truly drawing that much.

Will lightening the load help?

It does no harm to try an empty spin. If code 112 still appears with nothing in the drum, the measurement circuit is the likely issue and needs a technician.

What happens at the visit?

We confirm the code, test the motor control module, and give a written price before replacing it. Our repairs come with a 30-day workmanship warranty.