Fisher & Paykel SmartDrive Code 2: Error reading the pressure sensor

What 2 (SmartDrive) means

On Fisher & Paykel SmartDrive top-load washers in Phases 1 to 4, code 2 means an error was encountered when trying to read the pressure sensor. In Phase 1 the display module reports it; in Phases 2 to 4 the motor control module does. Without a good pressure reading the washer cannot judge its water level, so the cycle stops with the number showing. It does not apply to Phases 5 and 6.

Common causes of 2 (SmartDrive)

Pressure sensor could not be read
Pressure sensor or its wiring failing
Display module (Phase 1) or motor control module (Phases 2 to 4) misreading the sensor

✓ One safe check you can try

1. Turn the washer off and run a full drain if water is in the bowl. 2. Unplug it for a minute and plug back in. 3. Start a short cycle and watch whether it fills to a sensible level. 4. If code 2 returns, stop using the washer and book service. The sensor and its tube are behind panels.

! Why to stop there

Water level sensing is what stops overfilling, so it should not be guessed at
The sensor, tube, and module each need separate tests
The sensor is inside the cabinet near live parts

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 246Fisher & Paykel AquaSmart Code 246: wash boost valve error 247Fisher & Paykel AquaSmart Code 247: Smart Pump flapper error 248Fisher & Paykel AquaSmart Code 248: Smart Pump top-up error 232Fisher & Paykel Top-Load Washer Code 232: Communications timeout after 5 seconds

2 (SmartDrive)2 (SmartDrive) questions

Which phases show code 2?

Phases 1 to 4 of SmartDrive. The module that raises it differs: the display module in Phase 1, the motor control module in Phases 2 to 4.

Does it mean the water level is wrong?

It means the control could not read the pressure sensor that measures the level. The washer stops rather than guess how full the bowl is.

What does a visit include?

We test the sensor, tube, and module, quote the price in writing before work, and cover repairs with a 30-day workmanship warranty.