Fisher & Paykel AquaSmart/EcoSmart Top-Load Code 74: water-Level sensor signal out of range

What 74 means

On Fisher & Paykel AquaSmart/EcoSmart top-load washers such as the WA37T26EW and WA42T26GW, code 74 is a pressure transducer error: the transducer frequency is out of range. The water-level sensor sends a signal the control cannot accept, and the remedy is to replace the Motor Control Module. The washer stops and shows 74. The signal comes from the sensor but is read by the control.

Common causes of 74

Pressure transducer signal frequency outside the allowed range
Motor Control Module not reading the sensor properly
Sensor wiring problem

✓ One safe check you can try

1. Let the tub drain and remove the clothes. 2. Turn the washer off and switch off its breaker for one minute. 3. Restore power and run a short rinse. 4. If 74 appears again, stop using the washer and call us for a Motor Control Module check.

! Why to stop there

The sensor signal is read on the control board, inside the cabinet.
Parts have to be tested, since several can cause the same code.
Price in writing first, 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 235Fisher & Paykel Top-Load Washer Code 235: Lid lock short circuit 253Fisher & Paykel AquaSmart Top-Load Code 253: SmartPump drawing high current 236Fisher & Paykel Top-Load Washer Code 236: Incompatible EEPROM version 254Fisher & Paykel EcoSmart Code 254: motor control software too old

7474 questions

What is the transducer frequency?

The water-level sensor reports level as a signal frequency. If that frequency falls outside the accepted range, the control shows 74. That signal must stay inside a narrow band to be accepted.

How does 74 differ from 73?

Code 73 means the wrong sensor type is fitted. Code 74 means the signal from the sensor is outside the accepted range. Both are water-level sensor codes on this platform.

Do I need a new control?

The usual remedy is a new Motor Control Module. We test first and give the price before replacing anything. We test the sensor and module together before ordering.