Fisher & Paykel SmartDrive Code 54: motor step test found no current

What 54 (SmartDrive) means

On Fisher & Paykel SmartDrive Phase 2 to 6 top-load washers such as the GWL11 and GWL15, code 54 is a motor and Motor Control Module step failure. The module attempted a motor step test, found that the motor did not step to the correct position, and detected that there is no current. That points to a motor that is not connected or is open circuit. The owner sees 54 at the start of the cycle.

Common causes of 54 (SmartDrive)

Motor not connected or connector loose
Motor winding open
Motor Control Module drive output not supplying current

✓ One safe check you can try

1. Unplug the washer for several minutes. 2. Check that the basket moves freely by hand. 3. Plug in and try one empty cycle. 4. If 54 returns, leave the washer off and call us.

! Why to stop there

No current could mean the motor, the wiring or the module output
We test the path before ordering anything
A written price comes first, with a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 239Fisher & Paykel AquaSmart/EcoSmart and SmartDrive Ph6 Code 239: lid lock not responding door OPEnFisher & Paykel WH2424 Front-Load Message "door OPEn": close the door to start 240Fisher & Paykel Top-Load Washer Code 240: Hall sensor out of order Err + numberFisher & Paykel WH2424 Front-Load Display "Err" With a Number: washer stopped with an error code

54 (SmartDrive)54 (SmartDrive) questions

What does no current mean here?

The module sent a signal to move the motor and did not see electricity flow. Either the motor is not connected, it is open, or the module did not deliver power.

Is 54 a safety concern?

Low current is not a hazard in itself. The washer simply cannot run, so it stays off until the path is repaired.

Would a surge cause it?

A surge can damage the module output, but a loose motor connector can give the same result.