Fisher & Paykel SmartDrive Code 134: Phase 4 current trip and rotor position error

What 134 (SmartDrive) means

On Fisher & Paykel SmartDrive top-load washers in Phase 4, code 134 reports a single current trip together with a rotor position error. The motor controller saw a momentary excess current while the rotor position signal was also wrong. Both are motor drive protections, so the washer stops the cycle and shows the number. It is a Phase 4 message only.

Common causes of 134 (SmartDrive)

Momentary excess current in the motor drive
Rotor position signal error at the same moment
Wiring between motor, sensor, and controller

✓ One safe check you can try

1. Unload the washer, power it off, and unplug it for a minute. 2. Plug back in and run one short empty spin. 3. With the washer unplugged, check by hand that the drum turns freely. 4. If code 134 shows again, stop using it and book service. Motor, sensor, and wiring all sit beneath the tub.

! Why to stop there

Two related drive problems at once call for testing of the sensor and the motor circuit
Replacing parts blindly is costly and may not cure it
Work under the tub should be done only with power disconnected

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 240Fisher & Paykel Top-Load Washer Code 240: Hall sensor out of order Err + numberFisher & Paykel WH2424 Front-Load Display "Err" With a Number: washer stopped with an error code 241Fisher & Paykel EcoSmart Code 241: display function time-out 242Fisher & Paykel SmartDrive Phase 6 Code 242: out-of-Balance warning

134 (SmartDrive)134 (SmartDrive) questions

Why does code 134 name two problems?

The controller logged a current trip and a rotor position error together. They often travel together because the controller needs a good position signal to manage current.

Is this a Phase 4 only message?

Yes, this meaning belongs to Phase 4 SmartDrive washers. Other codes such as 130 and 132 cover the pieces separately.

Do you quote before repairing?

Always. We give the price in writing before work starts, and our repairs include a 30-day workmanship warranty.