Fisher & Paykel Top-Load Washer Code 133: Repetitive current trip

What 133 (SmartDrive) means

On Fisher & Paykel AquaSmart and EcoSmart top-load washers like the WA37T26EW and WA42T26GW, and on SmartDrive Phase 1 to 4 machines, code 133 is a repetitive current trip. The motor control module detected excess current in the motor or electronic switches, again and again. It is a more severe occurrence than code 132 but has the same sources and the same service procedure. The washer stops with the number displayed.

Common causes of 133 (SmartDrive)

Excess current in the motor or electronic switches, repeating
Motor winding, wiring, or drive switches to blame
Motor control module protecting itself

✓ One safe check you can try

1. Turn the washer off and unplug it for a full minute. 2. Take the clothes out, plug back in, and try one short empty spin. 3. With power off, lift the lid and confirm the drum turns by hand. 4. If code 133 comes back, do not keep trying. Leave the washer unplugged and call us.

! Why to stop there

Repeated trips mean the cause is persistent, not a one-time event
Further attempts can burn out the drive switches
Diagnosis needs measurements on the motor and module

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 234Fisher & Paykel Top-Load Washer Code 234: Lid lock open circuit 252Fisher & Paykel EcoSmart Code 252: motor bridge test failed 235Fisher & Paykel Top-Load Washer Code 235: Lid lock short circuit 253Fisher & Paykel AquaSmart Top-Load Code 253: SmartPump drawing high current

133 (SmartDrive)133 (SmartDrive) questions

How is code 133 different from 132?

Both report excess current. Code 132 is a single trip; code 133 means the trip keeps repeating, which is more severe, though the service steps are the same.

Can I run it again to see if it clears?

One empty test spin is reasonable. Beyond that, repeated trips can damage the drive electronics, so stop and let a technician check the motor and module.

What is typically replaced?

It depends on what testing shows, so we do not guess. We explain the finding, quote in writing, and back the work with a 30-day workmanship warranty.