Fisher & Paykel AquaSmart/EcoSmart Top-Load Code 224: control peripheral error

What 224 means

On Fisher & Paykel AquaSmart/EcoSmart top-load washers like the WA37T26EW and WA42T26GW, code 224 is a Motor Control Module peripheral error. The processor on the module could not communicate properly with one of its own supporting circuits. The washer stops the cycle and the display shows 224 until the module is checked. Water in the tub, if any, stays put until a technician drains it. Nothing you did on the panel caused this error.

Common causes of 224

Motor Control Module peripheral circuit error
Electrical disturbance interfering with the module
Motor Control Module needs replacement

✓ One safe check you can try

1. Switch the washer off at the control. 2. Turn off its breaker for one minute and then restore power. 3. Select a short rinse with an empty tub. 4. If 224 stays, stop using the washer and call us; we handle the module.

! Why to stop there

The affected circuits are part of the control board and cannot be reached safely.
Only a proper test separates a one-time glitch from a failing board.
We quote in writing before work and cover it with a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked 242Fisher & Paykel SmartDrive Phase 6 Code 242: out-of-Balance warning 243Fisher & Paykel EcoSmart Code 243: motor stepper test failed 245Fisher & Paykel AquaSmart Code 245: Smart Pump stalled 246Fisher & Paykel AquaSmart Code 246: wash boost valve error

224224 questions

What is a peripheral in this code?

It is a supporting circuit on the control module that the processor depends on. If the processor cannot work with it, the module reports 224.

Why does the washer stop completely?

The module cannot trust its own supporting circuits, so it halts the cycle instead of running the motor and valves blindly. That protects the motor, valves and pump from wrong commands.

Is a restart worth trying?

Yes, once. A power cycle clears an occasional glitch, but a repeat of 224 means the module has a real problem. If it comes back, the module needs a proper board test.