Fisher & Paykel SmartDrive Phase 2-6 Code 161: control hardware and memory mismatch

What 161 means

Code 161 on Fisher & Paykel SmartDrive Phase 2 to 6 top-load washers is a hardware and EEPROM supply mismatch. The Motor Control Module is built for either 110 V or 230 V, and its stored configuration data does not match that hardware setting. The control refuses to run the motor and the display shows 161, usually after a board replacement.

Common causes of 161

Motor Control Module hardware voltage version differs from the stored configuration
Wrong replacement Motor Control Module fitted
Stored configuration memory not matching the board

✓ One safe check you can try

1. Turn the washer off and unplug it, or switch off its breaker, for one minute. 2. Power it up again and try the power button. 3. Leave it alone if 161 returns. 4. Call us and mention whether a control board was replaced; we will bring the matching module.

! Why to stop there

A control built for the wrong supply voltage must be replaced, not reset.
Configuration data cannot be edited from the front panel.
We quote the price in writing and include a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 233Fisher & Paykel Top-Load Washer Code 233: EEPROM read error from the motor control module 250Fisher & Paykel AquaSmart Code 250: Smart Pump lost sync 234Fisher & Paykel Top-Load Washer Code 234: Lid lock open circuit 252Fisher & Paykel EcoSmart Code 252: motor bridge test failed

161161 questions

What are 110 V and 230 V doing in this code?

The Motor Control Module is manufactured for one supply voltage. Its memory records which one, and 161 appears when hardware and memory disagree. It is a stored choice, not a setting you can change.

Does 161 mean a power problem at my house?

No. Your outlet is not the issue. The code is about the control module's own hardware and memory not agreeing with each other. The mismatch lives entirely inside the control module itself.

Can this appear on its own?

It most often follows a control replacement, though damaged memory data can cause it too. Either way, a technician has to match or replace the module.