Fisher & Paykel SmartDrive Code 46: Intuitive Display EEPROM error

What 46 means

On Fisher & Paykel SmartDrive Phase 5 top-load washers with the Intuitive Display, code 46 means the display detected a problem with its internal EEPROM. That is the memory chip that stores its settings. The owner sees 46 on the display, and the washer may reset its settings, behave oddly or refuse to start.

Common causes of 46

EEPROM memory inside the display damaged
Display module failing
Power disturbance while settings were saved

✓ One safe check you can try

1. Unplug the washer for five minutes. 2. Plug it back in directly and switch it on. 3. Try one short cycle. 4. If 46 returns, stop and call us.

! Why to stop there

A memory chip inside the display is not an owner repair
A replacement display must match the washer
We confirm and quote in writing first

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 233Fisher & Paykel Top-Load Washer Code 233: EEPROM read error from the motor control module 250Fisher & Paykel AquaSmart Code 250: Smart Pump lost sync 234Fisher & Paykel Top-Load Washer Code 234: Lid lock open circuit 252Fisher & Paykel EcoSmart Code 252: motor bridge test failed

4646 questions

What is the EEPROM?

It is a small chip that holds the display's stored settings. If it cannot be read or written reliably, the display reports 46.

Is this on every SmartDrive?

The meaning belongs to the Phase 5 washers with the Intuitive Display.

Will a restart clear it?

A restart might show a normal screen once, but if the chip is damaged 46 returns.