Fisher & Paykel SmartDrive Phase 1 Code 8: display module would not start up

What 8 means

Code 8 on Fisher & Paykel SmartDrive Phase 1 top-load washers means the Display Module micro was unable to start up correctly. The small processor on the display did not boot, so the washer could not begin normal operation. This code belongs to the earliest SmartDrive phase and appears on older machines only. It stops the washer before any cycle can start.

Common causes of 8

Display Module processor failed to start
Power interruption during start-up
Display Module needs replacement

✓ One safe check you can try

1. Unplug the washer or turn off its breaker for one minute. 2. Restore power and press the power button. 3. Wait for the display to start. 4. If 8 returns each time, stop and call us with the model number.

! Why to stop there

The processor is on the display board inside the console.
Repeated restarts will not repair a display that cannot boot.
Written price first, 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 246Fisher & Paykel AquaSmart Code 246: wash boost valve error 247Fisher & Paykel AquaSmart Code 247: Smart Pump flapper error 248Fisher & Paykel AquaSmart Code 248: Smart Pump top-up error 232Fisher & Paykel Top-Load Washer Code 232: Communications timeout after 5 seconds

88 questions

What is the display micro?

It is the small processor on the display module that runs the buttons and screen. Code 8 says it failed to start correctly. It starts first, whenever power is applied.

Is this common on new washers?

It is listed for SmartDrive Phase 1, the earliest generation, so it is mostly seen on older washers. Older machines of that generation are where it turns up.

Can I try other buttons?

If the display cannot start, the buttons will not help. A power reset is the only safe step. Only a power reset helps, and a repeat means a new display is needed.