Fisher & Paykel SmartDrive Phase 2-3 Code 47: bowl did not disengage

What 47 means

Code 47 on Fisher & Paykel SmartDrive Phase 2 to 3 top-load washers is a bowl disengage error. The pressure sensor says the tub is empty, but the washer finds the bowl is still engaged instead of released. The mechanism that switches between wash and spin cannot move properly, so the cycle stops and the display shows 47. It is a drive release problem, not a leak.

Common causes of 47

Bowl (basket) clutch not releasing after draining
Pressure sensor reading empty while the bowl stays engaged
Drive mechanism or its sensing problem

✓ One safe check you can try

1. Wait until the washer is completely still. 2. Check that the tub drained and no clothing is caught around the basket. 3. Switch off the breaker for one minute and restore power. 4. Start a short drain/spin. 5. If 47 returns, call us.

! Why to stop there

The bowl release is part of the drive under the tub.
Water level readings and mechanics must be checked together.
We quote in writing and cover repairs with a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

KEY LOCFisher & Paykel WH2424 Front-Load Message "KEY LOC": control panel is locked no tAPFisher & Paykel WH2424 Front-Load Message "no tAP": water not reaching the washer out OF bALFisher & Paykel WH2424 Front-Load Message "out OF bAL": load needs rebalancing Sud LOCFisher & Paykel WH2424 Front-Load Message "Sud LOC": too many suds, washer paused 234Fisher & Paykel Top-Load Washer Code 234: Lid lock open circuit 252Fisher & Paykel EcoSmart Code 252: motor bridge test failed 235Fisher & Paykel Top-Load Washer Code 235: Lid lock short circuit 253Fisher & Paykel AquaSmart Top-Load Code 253: SmartPump drawing high current

4747 questions

What does bowl dis-engage mean?

The bowl, or basket, is locked to the drive during wash and should release afterward. Code 47 says it did not, even though the tub reads as empty.

Is water still in the tub?

The code assumes the pressure sensor shows empty. If you see standing water, tell us when you call so we plan for it. We check for water and mechanical release at the same time.

Is this on newer SmartDrive washers?

The code is listed for Phase 2 and 3. A newer washer would more likely show a different message. On a newer washer, tell us the exact model so we plan correctly.