Fisher & Paykel Range Code F1 19: Knob Encoder Connection to Clock Board

What F1 19 means

On current Fisher & Paykel OR30 and OR36 Series 7 and 9 ranges, such as the OR30SCG6X1 and OR36SDG6X1, and pro ranges like the RDV3-486GD and RIV3-486, F1 19 is a clock board message to check the connection between the encoders and the clock. The encoders read your knob turns. The display shows F1 19, and the knobs may not respond. Replace the part if needed.

Common causes of F1 19

A loose connection between the knob encoders and the clock board
A knob encoder that has failed
A damaged wire in the control panel area
Moisture or spills reaching the encoder connections

✓ One safe check you can try

1. Switch the range off at its breaker for a minute and back on. 2. Wipe the knobs and control area with a dry cloth; do not spray cleaner into the panel. 3. Turn each knob and see whether the range responds. 4. If F1 19 returns, call us. Do not pull the knobs off or open the control. On gas models, if you smell gas, leave the house and call the gas utility from outside.

! Why to stop there

The encoders are inside the control area where wiring is exposed.
Telling a bad encoder from a loose connection takes inspection.
We check the link first and replace only what is needed.
The price is written before work, and a 30-day workmanship warranty covers it.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

F2 18Fisher & Paykel Current Range Code F2 18: Power Board Oscillator Error F2 19Fisher & Paykel Current Range Code F2 19: Fan Stall Error A1Fisher & Paykel Current Range Alert A1: Oven Overheated, Cool Before Use A2Fisher & Paykel Range Alert A2: Door Cannot Lock for Self Clean A3Fisher & Paykel Range Alert A3: Door Stays Locked After Self Clean Er03Fisher & Paykel Induction Range Code Er03: Touch Control Area Covered or Wet F0-00Fisher & Paykel Legacy Range Code F0-00: Self-Clean Temperature Sensor Error F1 08Fisher & Paykel Range Code F1 08: Clock Board I2C Communication Error

F1 19F1 19 questions

What is an encoder?

It is the small part behind each knob that tells the control how far and which way you turned it. F1 19 says the clock board cannot reach it reliably.

Did spilled liquid cause this?

It can, if moisture got under the knobs. Dry the area and avoid spraying cleaner there. If the code stays, an encoder or connection needs inspection.

Can I still cook?

It depends which controls respond. If knobs do nothing, the range cannot be used safely. Turn it off at the breaker and call us. Use the cooktop only if its own controls work normally.