Fisher & Paykel SmartLoad Dryer Code 6: Door Cannot Close

What Code 6 means

Code 6 on Fisher & Paykel SmartLoad and AeroSmart dryers, including the DEGX1, DGGX1, DE27CW1 and DG27CW1, is a user warning that the door is unable to close. Clothes are catching in the opening or the closing load is excessive. The display shows the code, and the cycle will not begin because the door does not register as closed. Most of the time the fix is as simple as removing a few items.

Common causes of Code 6

Clothing caught between the door and the opening
An overfilled drum pushing against the door
Lint or debris building up on the door edge
A door actuator that is struggling to close

✓ One safe check you can try

1. Open the door and take a few items out of the drum. 2. Check the rim and seal for any sleeve or sock trapped there. 3. Wipe away lint from the door edge. 4. Close the door gently and press Start. 5. If the dryer still shows the code with an empty drum, switch off the breaker for a minute, then call us if it persists.

! Why to stop there

With an empty drum and a clear rim, the code points at the door mechanism, which needs inspection.
Repeatedly slamming the door can bend latch parts.
We confirm whether it is load, lint or hardware before quoting anything.
You receive a written price and a 30-day workmanship warranty on any repair.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

Code 7Fisher & Paykel SmartLoad Dryer Code 7: Motor Current Too High Code 30Fisher & Paykel AeroSmart Dryer Code 30: Lid Failed to Lock Code 8Fisher & Paykel SmartLoad Dryer Code 8: Exhaust Temperature Too High Code 9Fisher & Paykel SmartLoad Dryer Code 9: Exhaust Temperature Too Low Code 10Fisher & Paykel SmartLoad Dryer Code 10: low 24 volt actuator supply Code 11Fisher & Paykel SmartLoad Dryer Code 11: lid lock open circuit Code 12Fisher & Paykel SmartLoad Dryer Code 12: lid lock switching failure Code 14Fisher & Paykel SmartLoad Dryer Code 14: unstable sensor module reading

Code 6Code 6 questions

Is Code 6 a repair call or just a reminder?

Usually it is a reminder. Lightening the load and freeing a trapped garment fixes it most of the time. A repair call makes sense only if it appears with an empty drum.

How full is too full?

If you have to press clothes down to shut the door, the load is too large. Split it into two smaller loads; the clothes also dry faster that way.

What if the door closes but the dryer still complains?

Then the dryer may not be sensing the door as closed. Try one power reset, and if the code remains, we should check the door actuator and latch.