Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Fisher & Paykel specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 322-9727 Request a Repair
Model library · Fisher & Paykel Built-In Coffee

EB24DSXB1

Fisher & Paykel EB24DSXB1 Black Trim Coffee Machine Service

Fisher & Paykel coffee system

Most common issues on this model

  1. Scale building up in the heating circuit
  2. Brew unit jamming mid-cycle
  3. Milk system clogging after use
  4. Grounds container not being sensed

Homeowners who choose the black-trim EB24DSXB1 normally have dark stainless or black glass elsewhere in the kitchen, and the machine sits flush in a wall column beside matching ovens. It sees daily use, sometimes several cups before lunch, so the wear we find is the kind that comes from volume rather than neglect.

The milk system is where most calls begin. Milk dries into the lines when it is not rinsed, and the narrow passages clog far faster than the water side. Next come the brew unit, which jams when coffee oil hardens on its slides, and the grounds container sensor, which can misread when the bin is seated slightly off.

We pull the unit forward, flush and inspect the milk lines, test the programmed drinks you saved, and give a written estimate before replacing anything.

Key features

  • 24-inch built-in bean-to-cup coffee maker
  • Black-trim version of the Contemporary Series 9 machine
  • Conical burr grinder and Thermoblock heating
  • Programmable drink memory
EB24DSXB1EB24DSXB1 questions
My black-trim machine stops mid-brew and shows a message about the brew unit. What happens?

The brew unit has stopped moving, because oily grounds have glued the slides. We remove it, clean and lubricate the travel path, check the drive motor and test several cycles, then reset your saved drinks if they were lost.

How should the milk system be cleaned on an EB24DSXB1?

Rinse after every milk drink and run the cleaning cycle on the schedule the display requests. If the foam turns weak or sputters, the lines are already partly blocked, and we can strip and flush them for you.

Do my programmed drink settings survive a repair?

Normally yes, because they are held in the machine memory. If we must replace the control board, the settings can reset, so we note your favorites before starting and enter them again before we leave.

Book a visit

Book repair for your EB24DSXB1

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Request a Repair